Print Page - AMOS 3D and AMOS Pro

Title: AMOS 3D and AMOS Pro
Post by: puni_gds on 19 Aug, 2007, 07:43 PM

Hi guys,

Recently I've been playing around with AMOS 3D in the good old AMOS the Creator. I usually tend to use AMOS Pro instead, and therefore I was wondering if there's a patch or something that will make AMOS 3D work in AMOS Pro. Thanks in advance for your help.

Title: Re: AMOS 3D and AMOS Pro
Post by: SamuraiCrow on 19 Aug, 2007, 10:39 PM

None that I'm aware of. AmosPro uses a different extension format from Amos the Creator.

Title: Re: AMOS 3D and AMOS Pro
Post by: Sidewinder on 20 Aug, 2007, 12:40 AM

The AMOS 3D extension works with both AMOS the Creator and AMOS Pro. There were two extension libraries that came on the AMOS 3D disk. The one titled AMOSPro_3D.Lib is the one that is for AMOS Pro. Just set it up in slot 4 in your config and make sure the AMOSPro_3D.Lib is in the APSystem drawer.

Edit: Actually, it may be that the AMOS Pro disk came with the AMOSPro_3D.Lib for AMOS 3D. I'll have to check when I get home.

Title: Re: AMOS 3D and AMOS Pro
Post by: Lonewolf10 on 07 Oct, 2007, 10:32 PM

Yes, there are 2 AMOS 3D extensions - Voodoo 3D 1.0 (AMOS:TC) and Voodoo 3D 1.02AP. Not sure where the later can be found, but I think I have them both :)

Certainly, I have used AMOS 3D to make 3 objects (my initials "ADB") which were used in a simple intro for one of my projects - been so long I can't remember which! :(

Regards,
Lonewolf10

Title: Re: AMOS 3D and AMOS Pro
Post by: puni_gds on 20 Oct, 2007, 07:37 PM

Thanks for the replies guys. I'll see if I can manage to get AMOS 3D working properly with AMOS Professional. Thanks again for the help. :)

Ultimate Amiga

Network Boards => AMOS Language Discussion => AMOS Factory => AMOS Professional Forum => Topic started by: puni_gds on 19 Aug, 2007, 07:43 PM